|
This page contains many wireless
security devices that will, when used in conjunction
with the driveway alarms advertised on the earlier
pages, provide an excellent level of security and
deterrence to any unwanted guests.
TELEPHONE DIALER WITH
ENTRY/EXIT DELAY
The
Dial Alert is a device that you can place in your home
or office which will automatically dial up to nine
pre-programmed phone or pager numbers of your choice
in the event of a problem.
Features:
Can be activated by several different accessory
sensors
Plays a 40 second personalized message for each of the
numbers you have programmed
Entrance and exit delay of up to 75 seconds to allow
deactivation
Battery backup
The following accessories may be used
with the dialer to optimize you security:
 WIRELESS
PIR SENSOR
This is a wireless passive infrared sensor that
will transmit a wireless signal to the telephone
dialer whenever an intruder enters an unauthorized
area. This unit detects the heat from the person as
they move into the area covered. The sensor will cover
an area of about 40' by 40'. Several transmitters may
be used to monitor different locations. The PIR sensor
operates by a 9 volt battery.
 WIRELESS
TEMPERATURE SENSOR
The temperature alert sensor detects
a temperature drop or rise. This unit works well when
used in conjunction with the dialer to monitor homes,
stores, outbuildings, etc when you are away. In the
event of a heat rise or loss the sensor will activate
the dialer to alert the proper parties. The sensor's
range is from -20 degrees to 110 degrees F and may be
adjusted to the high and low temperatures you
require.
 |
WIRELESS DOOR CONTACTS |
The wireless door contacts may be
mounted on any door and will activate the dialer when
the door is opened. The contacts, which use a 9 volt
battery, work well with the dialer because they make
full use of entry and exit delay on the dialer.
 |
WIRELESS HANDHELD TRANSMITTER |
This small transmitter , which uses
a 9 volt battery, can be carried in a pocket or purse.
It can activate dialer up to 300 feet away. It may
also be used as a panic button to summon for help for
those store with limited security that operate late
hours, such as convenience stores.
SIREN
The 12 volt DC siren can be plugged
into the dialer and will sound when activated. The
siren is designed for exterior us and could be used to
scare off an intruder. 120 DB
TIMER/ LIGHT CONTROL
The timer control , when activated
by our wireless drive alert, is normally used for
security reasons. It has the ability to turn on
lights, bells, horns, etc that can be set to stay on
for 2,5,10 minutes and then will shut off
automatically, or you may have the light, etc . turn
on until manually reset The control unit has an on/off
switch for use your convenience. Installation is very
easy- just connect the timer to the dry contacts on
the receiver and plug in the light. The timer control
can turn on up to 250 watts of light.
LOUD RINGING BELL
This 6" bell can be used with any of
the driveway alarms. It can be used outside or inside
for people with hearing problems. When used in
conjunction with the light/timer control it may be
programmed to ring up to one hour.
LINE CARRIERS
These are designed to send a remote
signal from one building to another, providing that
all locations are downstream from one power
transformer. Plug the transmitter into a 110 volt
outlet in one building, and throughout your existing
power lines, it will trip the receiver in another
building. The transmitter can be activated by a
driveway alarm. A loud bell or light plugged into the
receiver would be activated.
|
 |
STROBE |
| |
|
| This
strobe can be used for the hearing impaired as
well for use in noisy environments. The amber
color is best suited for this purpose. The strobe
has a flash rate of 90 flashes per minute.
|
|
This Motion-Activated Light Control requires
no wiring. It is ideal for chasing away
prowlers and intruders as well as improving
nighttime convenience and safety. When a dark
room or an outside area the sensor is
monitoring is approached, a light will go on
automatically for a period of five minutes and
then shut off. The wireless motion sensor is
weather sealed for long life and activates the
plug-in receive from up to 100' away, with the
signal passing through doors, walls and
floors. An override feature allows you to turn
lights on and leave them on. Requires 4 AA
alkaline batteries, (not included). |
Wireless Motion-Activated Light Control
- Transmits to 100 feet
away
- Turns a light on for
five minutes
- Keep prowlers away or
you will not have to search for the light
switch in the dark.
- Operates independently
of driveway alarm
|
|
|
|
|
LINE
DRIVER
